Charge the Battery
KEYPAD
GETTING STARTED
Insert the Battery
X2 General Purpose
1. Insert battery contacts into the hole of the
battery box as shown in the picture below
THE TERMINAL
With Single Slot Dock
Do not use the Joya X2 until
batteries are charged for
minimum 4 hours.
CAUTION
NOTE
2. Unscrew and remove the bottom cover
1. Programmable Function Keys.
2. Scan Key – Use it to turn on the Joya X2.
We recommend that the Joya X2
GP is used only for WiFi
*
D. Laser Safety Label
applications.
The
microUSB
A. Color Display
B. Front Scan Key
C. Keyboard
RESETTING THE JOYA X2
connector is intended only for
occasional communications.
E. Product Label
F. Micro USB Port
G. Cold Boot Button
Cold Boot
Simultaneously press F1 + F2 + ENTER
Or
Press with a pin or a paper clip the cold boot
button on the back of the mobile computer.
*. Remove protective film cover before use
Warm Boot
3. Insert the top cover, then insert the bottom
cover and fasten it with a screwdriver
Simultaneously press SCAN + ENTER.
Clean Boot
1. Perform a cold boot
2. As soon as the device is rebooting, press
simultaneously Esc + ENTER, holding both
keys down for few seconds
3. Press ENTER to confirm.
Suspend
H. Data Capture
Window
I. Dock Contacts
Simultaneously press SCAN + F1
Resume from Suspend
Press SCAN.
|